Rack Enclosures
Secure contents of existing pallet rack with WireCrafters Rack Enclosures. System uses standard sized panels (and posts-if necessary) and hinged or sliding gates to enclose any rack system. Enclosure may be mounted directly to rack or free standing. Free design and layout assistance available.

Features

Standard sized panels 4' 0" or 5' 0" high, match beam length in width.
Panels made of 2" x 2" x 10 gauge welded wire mesh-other meshes available.
Panels are framed in 1-1/4" x 1-1/4" x 13 gauge steel angle.
Panels attach directly to rack with mounting brackets.
Multiple mounting points (seven) on ends of each panel.
Stack panels one on top of the other to top of rack system.
Access racks via double sliding doors, or double hinged doors.
"Above the Top" mounting allows panels to extend above top rack beam.
Welded wire construction allows for factory finished looking field modifications.
Panels can be mounted to support posts if stand alone system desired.

Panels Rack Enclosure panels are made of 2" x 2" x 10 gauge welded wire mesh framed in 1-1/4" x x1-1/4" x 13 gauge steel angle. Panels are either 4' 0" or 5' 0" tall by 1' 0" to 12' 0" wide-stack two or more panels to reach full rack height. Panels can be mounted directly on the rack, or to posts if a stand alone system is desired. Panels may be installed above the top rack beam with our extension kit, or top panels may be added to fully enclose the rack system.
Doors Rack Enclosure doors are made of the same materials as the panels. Choose from sliding or hinged type doors. Doors can be mounted directly to the rack, or in some instances mounted on posts installed adjacent to the rack. Many stock and custom sizes are available.
Options WireCrafters stocks many different styles and types of mesh should your enclosure require heavier duty or tighter control than our standard 2" x 2" mesh provides. Review our Special Mesh page for details. Standard enclosure color is gray, see our Finishes & Colors page for alternatives.

Panels Shall be constructed of 2" x 2" x 10 gauge welded wire mesh completely framed in 1-1/4" x 1-1/4" x 13 gauge steel angle.
Doors - Hinged shall be constructed of the same mesh as the panels, completely framed in 1-1/4" x 1-1/4" x 13 gauge steel angle, two 1/4" x 3/4" horizontal stiffeners across the width, and two diagonal 1/4" x 3/4" stiffeners from door center to the corner securely welded in place. Hinged doors shall be equipped with padlock lugs (cylinder lock optional), three 4" x 4" spun pin hinges, and pick plate/slam bar assembly.
Doors - Sliding shall be constructed of the same mesh as the panels, completely framed in 1-1/4" x 1-1/4" x 13 gauge steel angle, two 1/4" x 3/4" horizontal stiffeners across the width, and two vertical 1/4" x 3/4" stiffeners from center of door to door top or bottom, securely welded in place. Sliding doors shall be equipped with two 4 wheel trolley trucks, 1-7/8" x 2-3/8" door track, pad lock lugs (cylinder lock optional), and door keeper assembly.
Posts Shall be made of 2" x 2" x 14 gauge steel tubing. Base plates of 2" x 7" x 1/4" steel flat with two 7/16" round holes for anchoring, shall be welded to each tube. Posts are factory drilled with pilot holes to accept self tapping screws for mounting panels.
Hardware All hardware needed for installation, including floor anchors shall be plated and is furnished as standard.
Finish Non-plated parts receive one coat of gray acrylic enamel. Touch up paint included with each shipment.